Fuse^® Foam |   CSI^®

Ready-to-Use Termiticide/Insecticide

Fuse Foam Ready-to-use Termiticide/Insecticide is labeled for direct injection into termite and ant nests and galleries, structural voids, and other listed sites. Ideal expanding foam prevents spread inside structure. Design allows the ability to reach those tough-to-treat places. Contains 0.005% Fipronil and 0.025% Imidacloprid. Available in 20 ounce can.

Use Sites: For use in and around structures and limited outdoor spot treatments

Effective Against: Termites, Wood Destroying Insects, Ants, Carpenter Bees, Asian Lady Beetles, Boxelder Bugs, Cluster Flies, Elm Leaf Beetles, Bean Plataspids, Brown Marmorated Stink Bugs

Active Ingredients: Fipronil 0.005%, Imidacloprid 0.025%

ENVIRONMENTAL HAZARDS Do not apply within 15 ft of bodies of fresh water: lakes, reservoirs, rivers, permanent streams, marshes, natural ponds and commercial fishponds. A 15 ft buffer of uniform groundcover must exist between the application area and bodies of fresh water (uniform ground cover is defined as land which supports vegetation of > 2” throughout). Do not apply within 60 ft of estuarine bodies of water. Estuarine water bodies are brackish, tidal water such as bays, mouths of rivers, salt marshes and lagoons. This product is highly toxic to aquatic invertebrates and is toxic to birds and fish. Do not apply directly to water, to areas where surface water is present or to intertidal areas below the mean high water mark. Runoff from treated areas may be hazardous to aquatic organisms in neighboring areas. Care must be taken to avoid runoff. Do not contaminate water by disposal of wastes. PHYSICAL/CHEMICAL HAZARDS CONTENTS UNDER PRESSURE. Do not use or store near heat or open flame. Do not puncture or incinerate container. Exposure to temperatures above 130° F may cause bursting. Avoid drilling areas near electrical wiring, plumbing, communication lines, etc. Do not apply product directly into any electronic equipment (i.e., radios, televisions, computers, etc), or where an electrical short circuit might result, such as in wall outlets, conduits, motors, switches, etc.